 |
 |
 |
|
|
|
[Sponsors] | ||||
September 3, 2019, 21:36
|
Nozzle topology control
|
#1 |
|
Senior Member
Join Date: Mar 2013
Location: B'lr
Posts: 130
Rep Power: 13  |
Hello all,
Started working on AutoGrid 11.2 recently. During flow path generation using Nozzle parameters, the elements are not distributing properly on the other side and ER is above 2(need <1.8) in this area as shown in figures. Tried to move the split line to control and increasing and decreasing the numbers that didn't work either. Could you please tell me which parameter needed to be altered to get equal distribution.? Thanks in advance |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inverse Design Optimization | khavart | SU2 Shape Design | 0 | June 20, 2019 03:37 |
| Match Control Matching Topology | Sean95 | FLUENT | 1 | May 12, 2018 07:59 |
| Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
| Adjoint - topology optimization - custom control volume | bramv101 | ANSYS | 3 | May 27, 2013 06:07 |
| compressible flow in a counterflow nozzle | d.vamsidhar | FLUENT | 0 | November 24, 2005 01:45 |
Linear Mode
