|
[Sponsors] |
May 12, 2018, 07:10 |
Match Control Matching Topology
|
#1 |
Member
Sean Gorry
Join Date: Feb 2018
Posts: 48
Rep Power: 8 |
I am trying to impose a match control between two faces for a cyclic BC. Both faces have the same area. When I try to mesh the problem, I get a "cannot find matching topology" error. Could this have something to do with the axis of rotation?
|
|
May 12, 2018, 07:59 |
|
#2 |
Member
Sean Gorry
Join Date: Feb 2018
Posts: 48
Rep Power: 8 |
The issue was due to the centre of the part rotation not being at x=0 y=0
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] The mesher cannot find matching topology | amin.z | ANSYS Meshing & Geometry | 1 | May 8, 2017 03:29 |
Match Control and Periodic BC ANSYS 12.1 | combustion | FLUENT | 2 | April 3, 2017 03:42 |
[ANSYS Meshing] Match Control, is this weird or am I stupid? | Moufle | ANSYS Meshing & Geometry | 2 | November 18, 2015 16:00 |
Match Control and Symmetry Boundary Condtions in a quasi 2D calculation | peterputer | ANSYS Meshing & Geometry | 0 | May 15, 2012 08:53 |
gmsh2ToFoam | sarajags_89 | OpenFOAM | 0 | November 24, 2009 22:50 |