|
[Sponsors] |
![]() |
![]() |
#1 |
Senior Member
|
Hi all!
I have installed OpenFOAM following README instructions for my Kubuntu 8.04.1. After that cavity tutorial did not work at stage of runnig 'paraFoam' asking for proper reader plugin. So I found solution at this forum to recompile ParaView and PV3FoamReader. Now it starts, but after loading cavity geometry representation window is to small (output region is about only 1/8 of total graphics window, other part is black). Mesh drawing is to small that I could not see almost anything. Perhaps it is connected somehow with OpenGl settings? I have NVIDIA Quadro FX 1400 with drivers installed from nvidia home site. Waiting for your suggestions! Thank you!
__________________
Best regards, Dr. Alexander VAKHRUSHEV Christian Doppler Laboratory for "Metallurgical Applications of Magnetohydrodynamics" Simulation and Modelling of Metallurgical Processes Department of Metallurgy University of Leoben http://smmp.unileoben.ac.at |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] ParaView small graphical window | makaveli_lcf | ParaView | 5 | March 23, 2009 04:48 |
Graphical error | hesam | FLUENT | 0 | February 10, 2007 04:15 |
Compile UDF without graphical interface? | Laura | FLUENT | 0 | September 5, 2006 10:26 |
Graphical technics | indd | Main CFD Forum | 2 | October 21, 2004 08:19 |
Graphical pressure distribution from a cut | Aline | Siemens | 3 | August 4, 2004 11:50 |