[waves2Foam] Compiling with OF 2.4.0: "Command not found: waveFoam"

Peter Ko · June 28, 2016, 03:08

Hello Foamers,

I downgrade my OF to 2.4.0 and sure that the installed was completed. However, I can't run the waveFoam application, while I type the command "waveFoam" after the "blockMesh".
The terminal just report the "Command not found: waveFoam"

So, how should I do in the next step??

I have tried to re-Allwmake and I got some errors as the attachment.

Best regards to every one

Peter Ko

kenrichaiz · June 29, 2016, 23:43

Dear Peter,
I believe something went wrong to your solver compilation, did you install the necessary dependencies like gfortran and git?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM.org] Error compiling VOF HARDT Solver on OpenFoam 2.4.0	saddy	OpenFOAM Installation	4	December 1, 2020 02:36
Problems compiling custom interPhaseChangeFoam with OpenFOAM 2.4.0	abdoli	OpenFOAM Programming & Development	1	October 6, 2016 08:46
[Other] How to create an MRF zone ?	aminem	OpenFOAM Meshing & Mesh Conversion	2	December 8, 2014 10:45
Regarding FoamX running Kindly help out	hariya03	OpenFOAM Pre-Processing	0	April 18, 2008 04:26
Problem with rhoSimpleFoam	matteo_gautero	OpenFOAM Running, Solving & CFD	0	February 28, 2008 06:51

June 29, 2016, 23:43		#2
kenrichaiz New Member Kenric Join Date: Mar 2016 Posts: 18 Rep Power: 10	Dear Peter, I believe something went wrong to your solver compilation, did you install the necessary dependencies like gfortran and git?