|
[Sponsors] |
April 12, 2015, 07:32 |
porous wave breaker problems
|
#1 |
Member
Rafael Marques
Join Date: Mar 2014
Location: Almada/Mülheim a.d. Ruhr, Portugal/Germany
Posts: 67
Rep Power: 12 |
Hi Mr.Jacobson and waves2foamers,
I am trying to simulate a porous Wave breaker and after successfully simulate a vertical wave breaker and a vertical porous wave breaker, I advanced to the next step; a porous wavebreaker with a certain steepness .But when I try this I qet problems at the interface of the porous and non-porous region. Right at the beginning of the simulation ( when the wave is generated ) I get some turbulences and strange particle movements at the interface face between the two regions, and this water displacement creates small waves in the opposite direction and the water fractions are being transported to the top of the wave breaker and through the air to the inlet. I used the same configuration for the vertical porous wave breaker and for the inclined one and i am getting this strange behavior. I dont know if it is a Meshing problem maybe I need to refine the zone at the interface when i introduce a steepness, or is there a conservation of mass problem? someone experienced something like this and have some advices or ideas for this problem? I'm using OpenFoam 2.2.2, and a Mesh with only rectangles and created with Gmsh greeting everybody Rafael Marques Last edited by rafa13; April 12, 2015 at 18:18. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
Turbulence dissipates too much energy for interFoam to simulate wave breaking | jasonchen | OpenFOAM Running, Solving & CFD | 5 | May 18, 2019 09:21 |
Problems calculating flow through porous domain | Schwimmy | CFX | 0 | March 8, 2017 05:14 |
[General] Problems with streamlines for 2D porous media flow simulations | twophaseflow | ParaView | 4 | February 11, 2014 14:32 |
Problems with porous jmp boundary type | Marijo | FLUENT | 2 | February 1, 2006 05:14 |