|
[Sponsors] |
[OLAFLOW] How to simulate compressible flow by olaFlow |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 7, 2021, 11:12 |
How to simulate compressible flow by olaFlow
|
#1 |
New Member
George
Join Date: Jun 2020
Location: Taiwan
Posts: 3
Rep Power: 5 |
Good afternoon Dr. Higuera,
First of all, thank you for your outstanding contribution, I had used this solver to simulate wave transmission in the Rubble Mound Breakwater with the backfill, and published the research results in the domestic Ocean Engineering Conference. Now I want to simulate compressible flow in the same pore structure & wave conditions. To compare with incompressible flow and compressible flow simulate result. Maybe i should combine olaFlow and compressibleInterFoam(C++ syntax is hard for me) or just need to adjust some parameters to achieve compressible flow in olaFlow? Any insight or knowledge would be greatly appreciated. Thanks George |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Intuition for why flow follows convex surfaces | lopp | Main CFD Forum | 47 | February 1, 2022 13:14 |
VOF compressible two-phase flow | lzhaok6 | Fluent Multiphase | 0 | August 17, 2020 17:17 |
About compressible and incomprehensible flow | granzer | Main CFD Forum | 8 | September 13, 2019 03:52 |
Attempt to simulate compressible flow in a diffusing S-Duct | landsber | SU2 | 1 | May 30, 2019 19:20 |
how to set BC for compressible flow target mass flow rate | foolboy007 | FLUENT | 1 | April 4, 2012 03:24 |