[shenzhou1987]

Hello everyone!
Recently I'm installing OpenFOAM 2.3.0 on CentOS6.6, and it's a Virtual Machine built by VMware 10. According to the guide of source installation, I have installed gcc, openmpi and everything. Before beginning installation I checked their version by executing cmd in the terminal like this:
$gcc --version
$mpirun --version
And everything is OK, it shows gcc 4.7.2 and mpirun (Open MPI) 1.8.1.
Following the guide I added these words into .bashrc:
source $HOME/OpenFOAM/OpenFOAM-2.3.0/etc/bashrc
then I executed cmd:
$source .bashrc
No errors are reported, but when I check the version of mpirun again, the problem occured.
After I entered cmd $mpirun --version, it showed words as follow.
-----------------------------------------------------------------
Sorry! You were supposed to get help about:
opal_init:startup:internal-failure
But I couldn't open the help file:
/home/shenzhou1987/OpenFOAM/ThirdParty-2.3.0/platforms/linux64Gcc/openmpi-1.6.5/share/openmpi/help-opal-runtime.txt: No such file or directory.Sorry!
-----------------------------------------------------------------
I don't know whether it's OK.And if I remove 'source $HOME/OpenFOAM/OpenFOAM-2.3.0/etc/bashrc' from file .bashrc, it will not appear. But in order to install OpenFOAM, I have to add these words into .bashrc. Then I execute './Allwmake' in folder 'OpenFOAM-2.3.0', and during the installation a warning message is reported as follow.
checking whether PMPI is enabled... no
configure: WARNING:***************************************
configure: WARNING:***VampirTrace cannot be built due to disabled MPI profiling.
configure: WARNING:***Pausing to give you time to read this message...
configure: WARNING:***************************************
So I don't know whether it will affect the installation or not. Can anybody give me some advice? Thank you.