 |
 |
 |
|
|
|
[Sponsors] | ||||
March 7, 2020, 09:41
|
log.make control
|
#1 |
|
New Member
Diego Turazza
Join Date: Mar 2020
Posts: 2
Rep Power: 0  |
Hi all,
I'm trying to follow instruction on the link: https://openfoamwiki.net/index.php/I...7/Ubuntu/18.04 I'm using Ubuntu 19.10 instead of 18.04. I attach the log.make file, as written at par. 11.3 because I cannot recognize if there is some errors in the installation. The installation was without any particular remark by OS, nor errors neither warning messages. Can someone look at the log file? I needed to change the name to log.txt to upload it. I note some "error" word at the end of the file, I wish to know if it is not a problem or if should repeat the installation with some aid. I hope this is the correct place to write this. Thanks a lot. Regards. Diego |
|
|
|
|
|
April 8, 2020, 08:36
|
|
#2 |
|
New Member
Diego Turazza
Join Date: Mar 2020
Posts: 2
Rep Power: 0 |
Any help??
Thanks |
|
|
|
|
|
 |
| Tags |
| log.make file, openfoam installation |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Monte Carlo Simulation: H-Energy is not convergating & high Incident Radiation | volleyHC | CFX | 5 | April 3, 2016 05:41 |
| Problem with an old Simulation | FrankW | CFX | 3 | February 8, 2016 04:28 |
| CFX FSI Fatal Error | unbanana | CFX | 0 | October 3, 2015 05:57 |
| FSI: Pressure and Normal Force don't match with expected values | Geraud | CFX | 6 | August 21, 2012 15:34 |
| Match Control and Symmetry Boundary Condtions in a quasi 2D calculation | peterputer | ANSYS Meshing & Geometry | 0 | May 15, 2012 08:53 |
Linear Mode
