|
[Sponsors] |
April 14, 2014, 19:39 |
split a patch face on subfaces?
|
#1 |
Member
|
Hi, I'm trying to make a mesh with blockMesh, but i'm in troubles because I need to split a face in two faces to impose different boundary conditions, My question is: is possible split a block face (patch) on sub-faces without create other block?. To clarify my question, in next fig I show the mesh made with one hex block (2 cells in x and 2 cells in y), in this fig is labeled the patch (right wall) that I can split to define a new patch, my question, Is possible to define a new patch without make other block (see fig2) ?
https://drive.google.com/file/d/0B_9...it?usp=sharing https://drive.google.com/file/d/0B_9...it?usp=sharing Thanks in advance for any hint. Felipe
__________________
Felipe G |
|
Tags |
blockmesh, patches |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
y+ and u+ values with low-Re RANS turbulence models: utility + testcase | florian_krause | OpenFOAM | 114 | August 23, 2023 05:37 |
[blockMesh] Internal walls of zero thickness | anger | OpenFOAM Meshing & Mesh Conversion | 23 | February 6, 2020 18:25 |
[snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 03:21 |
[GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 11:25 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |