|
[Sponsors] |
[snappyHexMesh] Background Mesh in snappy with multi domain (CHT) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 25, 2012, 10:13 |
Background Mesh in snappy with multi domain (CHT)
|
#1 |
New Member
Antonello
Join Date: Apr 2010
Posts: 20
Rep Power: 16 |
Good year everybody,
sorry for my bad english... I successfully meshed a multi domain with Fluent 13 mesher and then used it in OF1.7.1, but, i love open source then I am looking toward the capabilities of snappyHexMesh in multi doamin meshing. The geometry is very simple, an heated pipe and a cold fluid through it. I have follow this steps for case setup (reported in past post) based on snappyMultiReginHeater tutorial (in OF-1.7.1) 1) copy the case dir in the working folder. 2) modify the blockMeshDict (whole domain) 3) replace the stl files by SOLIDO.stl and FLUIDO.stl. stl files are obtain by exporting SALOME geom. 4) modify the regionProperties. 5) modify the snappyHexMeshDict to fit the new stl files. When I launch SHM the background mesh don't diasappear and it creates a domain0, SOLIDO and FLUIDO mesh. I have read thousand post and i: -modify the locationInMesh (pointed in FLUIDO, SOLIDO and domain0) -increase background mesh quality - etc .. but without success!!!! PLEASE HELP ME!!! Do you know how to delete the domain0 mesh? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[Gmsh] STL on Gmsh + Mesh on Snappy | adrieno | OpenFOAM Meshing & Mesh Conversion | 3 | May 20, 2016 12:22 |
injection problem | Mark New | FLUENT | 0 | August 4, 2013 01:30 |