|
[Sponsors] |
September 30, 2012, 08:33 |
converting interfaces to ami
|
#1 |
Member
|
Dears,
Can I convert a gambit mesh to OF2.1.x and then change the interface boundaries that defined in gambit to the ami bounadries in the boundary dictionary. I want to use it for dynamic mesh in OF. Best Regard, Hossein |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mapField error | rvl565 | OpenFOAM Pre-Processing | 1 | September 6, 2018 16:13 |
Translating and Rotating AMI | HiddenSquid | OpenFOAM Pre-Processing | 1 | October 25, 2017 03:59 |
AMI Motions: Ramped Rotation Speeds and Nested Sliding Interfaces | lordvon | OpenFOAM Programming & Development | 0 | September 24, 2013 01:30 |
dynamic Mesh is faster than MRF???? | sharonyue | OpenFOAM Running, Solving & CFD | 14 | August 26, 2013 07:47 |
mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |