|
[Sponsors] |
December 19, 2012, 05:56 |
A lot of questions by a beginner
|
#1 |
New Member
Join Date: Dec 2012
Posts: 7
Rep Power: 13 |
Hi,
i have a little problem. My adviser needs a simulation of the assembly(coldwallreactor) seeing in addendum. I have done the tuts on the openFoam page. Now my few questions 1.What foamer do i need for that? IcoFoam? 2. Is that possible to creat the mesh with blockMesh or should i take an other messure for that problem? 3. How shall i build up the mesh seeing sec. addemdum? a.Create a big block, than omit all „air“ areas( or b.Create the „solid“ blocks first and than omit the „air“ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Beginner questions - modelling lift and drag on a towed body | ABF | Main CFD Forum | 15 | October 19, 2014 23:27 |
Beginner questions - Compressibility or Rarefaction | Franz | Main CFD Forum | 0 | October 25, 2012 11:37 |
possible interview questions | atturh | Main CFD Forum | 1 | February 21, 2012 08:53 |
[ICEM] beginner questions for ICEM CFD | johnp | ANSYS Meshing & Geometry | 14 | August 10, 2010 17:45 |
NACA0012 Validation Case Questions | ozzythewise | Main CFD Forum | 3 | August 3, 2010 14:39 |