 |
 |
 |
|
|
|
[Sponsors] | ||||
February 23, 2016, 16:20
|
Generating hex meshes
|
#1 |
|
Member
Saurabh Tandon
Join Date: Nov 2015
Location: Austin
Posts: 43
Rep Power: 10  |
Hi
I am now using tet meshes for running simulations in OpenFOAM but its not working very well (very difficult to pass the checkmesh tests). I think it might be easier if I use hex meshes instead of tet meshes. Does anyone know a software that I can use for generating hex meshes from stacked binary images (hopefully opensource). Thank you. Saurabh |
|
|
|
|
|
February 24, 2016, 02:55
|
|
#2 |
|
Senior Member
Anton Kidess
Join Date: May 2009
Location: Germany
Posts: 1,377
Rep Power: 30 |
As an intermediate step, you can convert your tet mesh into polys via polyDualMesh.
__________________
*On twitter @akidTwit *Spend as much time formulating your questions as you expect people to spend on their answer. |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] --> FOAM FATAL ERROR: Trying to specify a boundary face | A.A. | OpenFOAM Meshing & Mesh Conversion | 41 | June 26, 2020 07:06 |
| [blockMesh] Openfoam: Meshing, where do my defaultFaces come from | syntex | OpenFOAM Meshing & Mesh Conversion | 19 | December 10, 2018 07:21 |
| [Other] mergeMatchPairs with arcs | vainilreb | OpenFOAM Meshing & Mesh Conversion | 1 | August 5, 2013 08:11 |
| [blockMesh] apparently the mesh doesn't want to be created in one direction | Maxime Thomas | OpenFOAM Meshing & Mesh Conversion | 1 | August 18, 2012 06:05 |
| CheckMeshbs errors | ivanyao | OpenFOAM Running, Solving & CFD | 2 | March 11, 2009 02:34 |
Linear Mode
