|
[Sponsors] |
[Other] Write out nonorthogonality and squness as fields? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 19, 2016, 20:23 |
Write out nonorthogonality and squness as fields?
|
#1 |
Member
Join Date: Apr 2015
Location: EU
Posts: 38
Rep Power: 11 |
Is it possible? Not just non-ortho faces but for all faces, so I can look at it in paraview.
Thank you,
__________________
beep-beep |
|
March 21, 2016, 00:43 |
|
#2 |
Senior Member
Join Date: Aug 2013
Posts: 407
Rep Power: 15 |
Hi,
Well, I am not sure about writing it as fields, but you can run checkMesh on your case and then use foamToVTK to convert the faceSets/cellSets to VTKs that can be viewed in Paraview. Cheers, Antimony |
|
March 22, 2016, 08:35 |
|
#3 |
Member
Join Date: Apr 2015
Location: EU
Posts: 38
Rep Power: 11 |
Thank you for your reply.
Thaths true, but that only works for highly-nonorthogonal faces. I would like to know this info for the entire mesh if possible, or at least for a range of nonorthogonality if that makes sense..
__________________
beep-beep |
|
March 23, 2016, 01:48 |
|
#4 |
Senior Member
Join Date: Aug 2013
Posts: 407
Rep Power: 15 |
Hi,
I actually stand corrected. Apparently you can do something of the sort that you mentioned using swak4Foam: http://www.cfd-online.com/Forums/ope...tml#post387378 Hope this helps. Cheers, Antimony |
|
|
|