|
[Sponsors] |
[snappyHexMesh] SHM Problems with snapping and layers |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 14, 2016, 14:52 |
SHM Problems with snapping and layers
|
#1 |
Member
Ruggiero Guida
Join Date: Apr 2013
Location: World
Posts: 46
Rep Power: 13 |
Dear Foamers,
I am struggling to get continuous layers on the mesh in the attached file. (The only geometry is 'fixed_surroundings.stl') I am using OF 3.01 As you can see from a horizontal and vertical section the layers are not continuous. I have also noticed that if I keep my refinements for features and surfaces below 6 then SHM does not snap to the top-left vertical edge. The series of commands that I run is the following: Code:
foamCleanPolyMesh blockMesh surfaceFeatureExtract decomposePar mpirun -n 2 snappyHexMesh -parallel reconstructParMesh foamToVTK Any idea? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Controlling y+ values with snappyHexMesh? | cjm | OpenFOAM Meshing & Mesh Conversion | 67 | July 10, 2019 19:56 |
[snappyHexMesh] SHM is not extruding/adding Layers everywhere | matthiasd | OpenFOAM Meshing & Mesh Conversion | 2 | October 16, 2016 17:45 |
[snappyHexMesh] SHM not snapping to some surfaces | Swift | OpenFOAM Meshing & Mesh Conversion | 13 | January 4, 2016 02:56 |
[snappyHexMesh] Fail to create boundary layers during sHM | farahiam | OpenFOAM Meshing & Mesh Conversion | 13 | October 15, 2014 20:46 |
[snappyHexMesh] Effect of adding layers with sHM | Nucleophobe | OpenFOAM Meshing & Mesh Conversion | 4 | August 20, 2012 17:45 |