[Other] Bad Mesh transition

BakedAlmonds · July 20, 2016, 08:04

Hi, I am using sHM and wonder if here is a way to specify the transition between the different mesh refinement level.
Attached is the mesh generated with bad transition.

Any suggestion of how to improve the mesh quality?
Thank in advance for the help, will be greatly appreciated!!

jherb · July 21, 2016, 05:18

What is the output of checkMesh? And are you sure that what you see is not an artifact of paraview. You might try to uncheck the setting "decompose polyhedra" and check the setting "crinkle clip/slice" (if your picture shows a clip or slice)

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface	Kryo	OpenFOAM Meshing & Mesh Conversion	13	February 17, 2022 07:34
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
[mesh manipulation] cfMesh + extrudeMesh -> bad quality mesh?	aerospacious	OpenFOAM Meshing & Mesh Conversion	1	July 28, 2020 02:57
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

July 21, 2016, 05:18		#2
jherb Senior Member Joachim Herb Join Date: Sep 2010 Posts: 650 Rep Power: 21	What is the output of checkMesh? And are you sure that what you see is not an artifact of paraview. You might try to uncheck the setting "decompose polyhedra" and check the setting "crinkle clip/slice" (if your picture shows a clip or slice)