 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] snapphexmesh with not quite orthogonal base mesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 24, 2016, 11:33
|
snapphexmesh with not quite orthogonal base mesh
|
#1 |
|
Senior Member
Derek Mitchell
Join Date: Mar 2014
Location: UK, Reading
Posts: 172
Rep Power: 13  |
Can sHM cope with a rhomboid base mesh ?
I have thin sections slightly inclined to each other so that a base mesh that follow the slight incline should yield better mesh if SHM can use it. The base mesh blocks are as per the attachment 
__________________
A CHEERING BAND OF FRIENDLY ELVES CARRY THE CONQUERING ADVENTURER OFF INTO THE SUNSET |
|
|
|
|
|
January 20, 2017, 01:27
|
|
#2 |
|
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
Yes, in general it can snap to any mesh but the less-orthogonal it gets the more difficult getting a good mesh will be.
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| [ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 05:03 |
| [snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 16:59 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Linear Mode
