|
[Sponsors] |
[mesh manipulation] refineMesh Problems: strange cells/cuts were added |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 18, 2015, 06:01 |
refineMesh Problems: strange cells/cuts were added
|
#1 |
New Member
Björn N.
Join Date: Jun 2013
Posts: 11
Rep Power: 12 |
Hello together!
I tried to refine my mesh via the refineMesh in OpenFoam 2.3.0. My mesh has a cylinder, surrounded by cuboid. As you can see in the pictures there is a problem with the inner cells. I used patchLocalCoeffs as follows: Code:
patchLocalCoeffs { // Normal direction is face normal of zero'th face of patch patch front; tan1 ( 1 0 0 ); tan2 ( 0 1 0 ); } Code:
***Concave cells (using face planes) found, number of cells: 142 <<Writing 142 concave cells to set concaveCells Thanks a lot for your help! |
|
Tags |
refinemesh |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[mesh manipulation] checkMesh Erros after refineMesh | mgdenno | OpenFOAM Meshing & Mesh Conversion | 10 | October 14, 2014 05:16 |
Im having some strange problems here | xTamx420 | FLUENT | 0 | June 1, 2011 15:00 |
Problems initializing a turbulence model | srinath | OpenFOAM Running, Solving & CFD | 3 | November 27, 2008 10:06 |
[Commercial meshers] Tgrid tetra mehs with problems | braennstroem | OpenFOAM Meshing & Mesh Conversion | 2 | June 18, 2007 03:39 |