 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] How to create layer that is normal to the surface of the geometry? |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 27, 2019, 07:52
|
How to create layer that is normal to the surface of the geometry?
|
#1 |
|
Member
Joe lee
Join Date: Nov 2018
Posts: 59
Rep Power: 7  |
I was trying to create a layer that is normal to the geometry edge/surface, which looks like this:
 However, what I got is something like this:  Can the layer mesh be refined to something like the first figure by adjusting parameters in snappyHexMeshDict? Thanks. |
|
|
|
|
| Tags |
| layer, normal to edge, snappyhexmesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh generates not planar surface | krzychu111 | OpenFOAM Meshing & Mesh Conversion | 2 | April 23, 2020 16:38 |
| [snappyHexMesh] Problem airfoil snappyhexmesh add layer | bye bye my blue | OpenFOAM Meshing & Mesh Conversion | 1 | May 5, 2017 05:56 |
| [snappyHexMesh] SnappyHexMesh: Layer on corners | Pj. | OpenFOAM Meshing & Mesh Conversion | 9 | July 17, 2014 04:26 |
| Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
| NACA0012 geometry/design software needed | Franny | Main CFD Forum | 13 | July 7, 2007 15:57 |
1Likes
Threaded Mode
