 |
 |
 |
|
|
|
[Sponsors] | ||||
July 8, 2019, 09:01
|
Gmsh to Stl file conversion
|
#1 |
|
Member
Mondal
Join Date: Sep 2018
Location: Canberra ACT
Posts: 68
Rep Power: 7  |
Hi Foamers,
I am new with snappyHexMesh and have initial idea about SHM. I am just wondering how to make a stl file using gmsh. I can convert *.geo file to *.stl file. The main question is that to make a complete geo file there is couple of steps. Point selection->Connecting point->Define surface->Extrude->Selecting boundary->Volume selection->Meshing For creating a complete stl file from geo file how long of these steps should I go? Does it necessary to go all the steps except Meshing? My thinking is that First four steps but not sure yet. Is that correct? One more question, How to make 2D meshing by SHM? Please help me out.. Cheers Razon |
|
|
|
|
|
July 8, 2019, 22:24
|
|
#2 |
|
Member
Mondal
Join Date: Sep 2018
Location: Canberra ACT
Posts: 68
Rep Power: 7 |
Can anyone help me out about this issue?
|
|
|
|
|
|
|
July 16, 2019, 01:06
|
|
#3 | |
|
Member
Mondal
Join Date: Sep 2018
Location: Canberra ACT
Posts: 68
Rep Power: 7 |
Quote:
|
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
| polynomial BC | srv537 | OpenFOAM Pre-Processing | 4 | December 3, 2016 09:07 |
| what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 01:22 |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
| [swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
Linear Mode
