 |
 |
 |
|
|
|
[Sponsors] | ||||
August 23, 2023, 12:59
|
|
#3 |
|
New Member
christopher van rees
Join Date: Jun 2021
Location: Chile
Posts: 9
Rep Power: 5  |
Maybe this is a bit too old, but I had a similar problem and maybe this can help someone.
What I did was basically give a "thickness" to the pipe, the solid cube with a pipe sticking out. Then I just did a cut with a "donut-shape" cylinder. Attached some images to help understand the process. Hope this helps someone. |
|
|
|
|
| Tags |
| salome, salome meshing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh not deleting the inside cells | Bdew8556 | OpenFOAM Meshing & Mesh Conversion | 9 | May 14, 2019 10:53 |
| Need Help! High pressure Gas discharge from tank to tank through a pipe | superarthur86 | FLUENT | 2 | June 16, 2017 10:22 |
| [snappyHexMesh] SHM error: inside mesh not possible | Naresh yathuru | OpenFOAM Meshing & Mesh Conversion | 1 | January 10, 2017 23:58 |
| Gas tank discharging | marian.nedelcu | System Analysis | 1 | July 12, 2016 13:32 |
| free surface inside a stirred tank | mystic_cfd | FLUENT | 5 | December 11, 2002 09:27 |
Threaded Mode
