[Other] Mesh with multiple nodes on face of the cell -- CFD Online Discussion Forums

July 16, 2020, 10:52	Mesh with multiple nodes on face of the cell	#1
zealotofvoid New Member Gorbachev Daniil Join Date: May 2016 Posts: 1 Rep Power: 0	Hello CFD community! Is it possible in OpenFoam to have multiple nodes on face of the cell? So for example I want to use tetrahedral cell and have 3 internal nodes on the each face. I can't find any information about it in internet. So I'm sorry if my search was not deep and someone has already asked this question somewhere. Best regards, Gorbachev Daniil.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
pimpleDyMfoam , AMI -- The mesh has multiple regions not connected by any face	coolcrasher	OpenFOAM Running, Solving & CFD	3	May 16, 2019 05:58
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
Warning 097-	AB	Siemens	6	November 15, 2004 04:41

All times are GMT -4. The time now is 09:22.