|
[Sponsors] |
[Other] Mesh with multiple nodes on face of the cell |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 16, 2020, 10:52 |
Mesh with multiple nodes on face of the cell
|
#1 |
New Member
Gorbachev Daniil
Join Date: May 2016
Posts: 1
Rep Power: 0 |
Hello CFD community!
Is it possible in OpenFoam to have multiple nodes on face of the cell? So for example I want to use tetrahedral cell and have 3 internal nodes on the each face. I can't find any information about it in internet. So I'm sorry if my search was not deep and someone has already asked this question somewhere. Best regards, Gorbachev Daniil. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
pimpleDyMfoam , AMI -- The mesh has multiple regions not connected by any face | coolcrasher | OpenFOAM Running, Solving & CFD | 3 | May 16, 2019 05:58 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |