|
[Sponsors] |
[snappyHexMesh] Error in the construction of boundary layers |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 7, 2021, 05:20 |
Error in the construction of boundary layers
|
#1 |
New Member
Dmitry
Join Date: Sep 2018
Posts: 12
Rep Power: 7 |
Hello everyone!
There was an error in drawing boundary layers. I set the parameters as indicated below, but the boundary layers are not drawn. The complete log from snappyHexMesh and the file itself are shown below. |
|
May 10, 2021, 08:39 |
|
#2 |
New Member
Jack B
Join Date: Jul 2018
Posts: 11
Rep Power: 7 |
Hi Kayano,
Let me point you to these threads where a similar problem are seen, Layer Addition and Prism Layers Not Generating. Layer addition problems are really common in snappyHexMesh and other open source meshers. I would suggest you start by checking out the links and increasing your feature angle to something like 130 and by switching off your tet quality setting in the mesh quality settings (minTetQuality -1e-30). Good luck |
|
May 11, 2021, 12:16 |
|
#3 |
Senior Member
M
Join Date: Dec 2017
Posts: 644
Rep Power: 12 |
Looks like addLayers is turned off completely. Check at the start of snappyHexMeshDict.
|
|
May 13, 2021, 15:40 |
|
#4 |
New Member
Dmitry
Join Date: Sep 2018
Posts: 12
Rep Power: 7 |
Thanks everyone, found a bug. The problem was the ratio. Set to 1.1
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Boundary layers on complex curves with good tetQuality | MikeWorth | OpenFOAM Meshing & Mesh Conversion | 0 | August 4, 2020 07:03 |
Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 05:15 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |