 |
 |
 |
|
|
|
[Sponsors] | ||||
May 28, 2021, 12:48
|
Hollow Cylinder mesh region
|
#1 |
|
New Member
Luca
Join Date: May 2021
Location: Italy
Posts: 1
Rep Power: 0  |
Hello everyone,
I have a geometry like the one I've attached in the link, and I have to create a hole in the middle of the internal pipe. This geometry is inserted in a duct. The problem is I have created a mesh region called fluid inside the duct and a second region called solid that corresponds to my stl. Is it possible to create a new mesh region called, for example, copper, related to the internal hole in the cylinder? And if yes, any idea of how to proceed using snappyhexmesh? Thanks Luca If the image does not work, this is the direct link https://ibb.co/tcc6kPz |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| Error when solving p_rgh | bob94 | OpenFOAM | 0 | March 17, 2020 08:12 |
| [Other] conformed FSI mesh for unstructured fluid region | ashish.svm | OpenFOAM Meshing & Mesh Conversion | 10 | August 2, 2019 08:40 |
| Prescribed Translating Cylinder Mesh for Added Mass Problem (Transient FSI) | Lloyd Sullivan | CFX | 5 | August 7, 2018 08:11 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
Linear Mode
