[sameedakber]

Hi All. I'm getting an error as follows when converting a 3D mesh using
fluent3dmeshtofoam:

Did not determine new position for face 3129785 owner 667929 neighbour -1 region -1
This is usually caused by not specifying a patch for a boundary face.
Switch on the polyTopoChange::debug flag to catch this error earlier.
points (removed points marked with (1.79769e+307 1.79769e+307 1.79769e+307)) 4((0.0795598 0 0.0254) (0.079923 0 0.025237) (0.0799237 0.002 0.0252432) (0.0795598 0.002 0.0254)).

I've specified all boundary face patches in ICEM. I'm struggling with this issue and would appreciate any help. Thanks. I've attached my mesh for flow in a rectangular channel around multiple cylindrical bodies.

[Ron.CC]

Originally Posted by sameedakber

Hi All. I'm getting an error as follows when converting a 3D mesh using
fluent3dmeshtofoam:

Did not determine new position for face 3129785 owner 667929 neighbour -1 region -1
This is usually caused by not specifying a patch for a boundary face.
Switch on the polyTopoChange::debug flag to catch this error earlier.
points (removed points marked with (1.79769e+307 1.79769e+307 1.79769e+307)) 4((0.0795598 0 0.0254) (0.079923 0 0.025237) (0.0799237 0.002 0.0252432) (0.0795598 0.002 0.0254)).

I've specified all boundary face patches in ICEM. I'm struggling with this issue and would appreciate any help. Thanks. I've attached my mesh for flow in a rectangular channel around multiple cylindrical bodies.

Hello.Sorry to bother but I'm meeting the same error.
Have you got the solution now? Thanks.