[Commercial meshers] some problems about transform interface in ICEM to cyclicAMI in openfoam -- CFD Online Discussion Forums

March 30, 2022, 00:21

some problems about transform interface in ICEM to cyclicAMI in openfoam

niumeng

New Member

NIUMENG

Join Date: Mar 2022

Posts: 2

Rep Power: 0

hello everyone.Can the area of the two sides of cyclicami be not same? I'm wondering if there's a problem here. For example, the following two faces.

Attached Images

Last edited by niumeng; March 30, 2022 at 03:32. Reason: post in wrong section

Tags

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Map of the OpenFOAM Forum - Understanding where to post your questions!	wyldckat	OpenFOAM	10	September 2, 2021 06:29
cyclicAMI bc - Error: Unable to set source and target faces	Claire88	OpenFOAM Pre-Processing	0	August 28, 2021 20:46
Error - Solar absorber - Solar Thermal Radiation	MichaelK	CFX	12	September 1, 2016 06:15
[ICEM] ICEM MRF Interface - Penetrating Elements	survADe	ANSYS Meshing & Geometry	9	February 4, 2015 03:26
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05

All times are GMT -4. The time now is 22:23.