 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] How to setup motorBike tutorial case with other meshing tools? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 14, 2022, 00:45
|
How to setup motorBike tutorial case with other meshing tools?
|
#1 |
|
New Member
Hà Nội
Join Date: Sep 2022
Posts: 1
Rep Power: 0  |
Hi all,
I'm a newbie with OpenFOAM, I've successfully run the motorBike tutorial case and rendered the visualization using Paraview. As I study the case, I see that it used snappyHexMesh for mesh generation. So, I wonder if it is possible to use motorBike tutorial case as a base, setup and run it with different meshing tools like cfMesh, GMSH or netgen? Thanks for your attention. I’m looking forward to your reply. Last edited by yhaki; September 14, 2022 at 00:46. Reason: Change thread's title |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 08:58 |
| The boundary conditions in the official tutorial motorbike | soyuku | OpenFOAM Running, Solving & CFD | 2 | August 15, 2020 00:34 |
| MapFields doesnt work in the "counterFlowFlame2D" tutorial case | panachristos | OpenFOAM Running, Solving & CFD | 9 | August 26, 2018 22:27 |
| Free surface boudary conditions with SOLA-VOF | Fan | Main CFD Forum | 10 | September 9, 2006 13:24 |
| Unsteady state case setup | Christian | FLUENT | 2 | February 16, 2003 18:11 |
Linear Mode
