|
[Sponsors] |
December 7, 2023, 13:42 |
Holes in Mesh after conversion
|
#1 |
Member
Anurag
Join Date: Feb 2023
Posts: 64
Rep Power: 3 |
Hi all, I have converted a 3D Mesh from Fluent to OpenFOAM that has got tetrahedral cells. But after conversion I can see some holes in the 3D as well as 2D mesh inside paraview. But this problem is not with hexa cels. Can anyone please suggest what is the problem? Is OpenFOAM not suitable for tetra cells? I attached the picture.
Many Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
flow over cylinder in openFoam | saeed jamshidi | OpenFOAM Pre-Processing | 3 | August 11, 2023 15:16 |
GeometricField -> mesh() Function | Tobi | OpenFOAM Programming & Development | 10 | November 19, 2020 11:33 |
[snappyHexMesh] Mesh contains holes on interface of multiregion case | DriesAllaerts | OpenFOAM Meshing & Mesh Conversion | 6 | December 17, 2019 04:43 |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 07:31 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |