 |
 |
 |
|
|
|
[Sponsors] | ||||
January 12, 2024, 07:06
|
dynamicMesh
|
#1 |
|
New Member
Join Date: Nov 2022
Posts: 20
Rep Power: 3  |
Hello,
I want to simulate a tube that decreases and after that increases its diameter at different parts (cellZones) according to some user determined compression value. Could you recommend me which motion solver should I use? I tried to use displacementLinearMotion, but it compresses the whole mesh. It could not be applied on different cellZones. How could I make it work on different cellZones? Or how could I compile my own motionSolver? Thanks a lot! Best Regards! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to set up correctFluxes in dynamicMesh? | qiancg | OpenFOAM Running, Solving & CFD | 0 | February 22, 2023 09:30 |
| DynamicMesh for Fish Motion | ShinGS | OpenFOAM Running, Solving & CFD | 1 | February 13, 2023 02:11 |
| InterFoam and dynamicMesh fatal error | Rasmusiwersen | OpenFOAM Running, Solving & CFD | 11 | February 23, 2020 04:51 |
| An error about the dynamicmesh file of pimpleDymFoam | zxzx | OpenFOAM Running, Solving & CFD | 4 | January 14, 2017 17:49 |
| External management of solid motion (using dynamicmesh) | maxou1993 | Main CFD Forum | 0 | July 28, 2015 11:37 |
Linear Mode
