|
[Sponsors] |
[snappyHexMesh] Missing elements near surface with snappyHexMesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 16, 2010, 17:27 |
Missing elements near surface with snappyHexMesh
|
#1 |
Member
Jean-Michel FONTAINE
Join Date: Aug 2009
Location: Orleans - France
Posts: 55
Rep Power: 16 |
Hello everybody
I'm struggling to solve mesh quality problems on the surface of my model : small holes due to missing elements near the model surface. These holes always occur near transition between patches with different levels I attached - a clipped view of flaw in volume - a view of the surface (from inside the volume) with 3 flaws - the snappyHexMeshDict Is the smoothness of the mesh at the surface normal ? I think that it is poor... I run OF1.7.1 on 64 bit Linux, compiled from sources Any tip would be appreciated Regards J-Michel |
|
Tags |
hole, quality, snappyhexmesh, surfaces |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh can't create refimenet region | clktp | OpenFOAM Meshing & Mesh Conversion | 3 | February 27, 2022 09:26 |
[snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 05:53 |
[ANSYS Meshing] missing internal faces and uncovered faces after redifining parts containing surface. | grv | ANSYS Meshing & Geometry | 2 | December 9, 2016 04:38 |
[snappyHexMesh] First try at snappyHexMesh... jaggies, weirdness and missing boundary layers :( | KarenRei | OpenFOAM Meshing & Mesh Conversion | 4 | October 15, 2016 19:42 |
[snappyHexMesh] Layers don't fully surround surface | EVBUCF | OpenFOAM Meshing & Mesh Conversion | 14 | August 20, 2012 04:31 |