|
[Sponsors] |
[mesh manipulation] cellSet: command not found |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 12, 2011, 16:28 |
cellSet: command not found
|
#1 |
Member
Shawn
Join Date: Oct 2011
Posts: 56
Rep Power: 14 |
I'm trying to execute the cellSet command, but get the error "command not found." I'm new to Ubuntu and OpenFOAM, however, the limited number of other commands I've used seem to be accessible. Perhaps it was something I did (or didn't do) when I installed OpenFOAM.
Ultimately, my goal is to simulate a vertical axis wind turbine. So far I have converted my .msh meshes (stator and rotor) to openfoam successfully, and I'm now trying to use cellSet to define my rotating region. Regards, and thanks, Shawn |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Insatlling gmsh from the source code-issue? | CFD-Lover | OpenFOAM Meshing & Mesh Conversion | 20 | June 12, 2018 06:39 |
8x icoFoam speed up with Cufflink CUDA solver library | kmooney | OpenFOAM Running, Solving & CFD | 42 | November 6, 2012 11:37 |
Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |
Problems Installing OF 1.6 32 bit | bucksfan | OpenFOAM Installation | 19 | August 4, 2009 01:36 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |