|
[Sponsors] |
[blockMesh] Mesh completely corrupt when increasing cell number |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 29, 2011, 18:35 |
Mesh completely corrupt when increasing cell number
|
#1 |
New Member
Sebastian P
Join Date: Jun 2010
Posts: 15
Rep Power: 15 |
Hello,
maybe someone here has experienced a similar problem: I created a simple mesh using blockMesh and when i doubled the cells in all directions, the mesh became completely weird, some cells aren't even Hexahedras. Does anyone know what the reason could be? Regards, Sebastian |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
SigFpe when running ANY application in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 23, 2015 14:53 |
foam-extend_3.1 decompose and pyfoam warning | shipman | OpenFOAM | 3 | July 24, 2014 08:14 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |