|
[Sponsors] |
September 24, 2012, 11:36 |
export STL from ParaView issues
|
#1 |
Senior Member
Rickard
Join Date: May 2010
Location: Lund, Skåne, Sweden
Posts: 143
Rep Power: 15 |
Hi all
Maybe I am using an old version of paraview but I dont think it should matter. Im trying to extract a surface from a given mesh into .STL but the output is just horrible. I added a picture of the liner, loooks messed up. Did anyone encounter this before? Best regs Rick |
|
September 24, 2012, 11:54 |
|
#2 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128 |
Greetings Rickard,
Apply the filter "Triangulate" before exporting. Best regards, Bruno
__________________
|
|
September 24, 2012, 11:58 |
|
#3 |
Senior Member
Rickard
Join Date: May 2010
Location: Lund, Skåne, Sweden
Posts: 143
Rep Power: 15 |
Bruno, I love you ! =)
Thanks Saved me alot of time BR Rick |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] Paraview export scene to EPS or PDF behaves differently in different versions | bgonzales | ParaView | 4 | August 4, 2021 10:32 |
[Gmsh] Export single patch from mesh to stl | krzychu111 | OpenFOAM Meshing & Mesh Conversion | 2 | April 27, 2021 08:48 |
A CFX-POST error (ver 14.5.7) | wangyflp88 | CFX | 2 | July 22, 2017 00:17 |
[General] A "clean" solution to export binary ensight gold format from Fortran to Paraview? | flotus1 | ParaView | 1 | June 23, 2015 11:59 |
Unable to install OpenFOAM 1.6-ext | Maimouna | OpenFOAM Installation | 23 | May 8, 2014 05:47 |