|
[Sponsors] |
January 28, 2013, 07:02 |
kEspsilon Refine Mesh
|
#1 |
Member
Ignacio
Join Date: Jan 2013
Posts: 33
Rep Power: 13 |
Hello all,
I am running a chtMultiregionFoam case of an annular flow channel, incompressible flow running at 0,14 m/s, P=70bar and sudden temperature change at inflow from 60 to 276ºC I use the high-Re kEpsilon model with kRWallFunctions for the boundary at the wall-cylinder The problem is that whenever I refine the mesh the solution changes a bit and I don't know how to say which one is correct Anyone has any idea about how to compute which one is the correct y+ value? I've read that it should be around 30 and 200 but I would like to have a more precise range And also... What is it supposed to be inside the first cell near the wall? The laminar sub-layer or the does it have to go till the logaritmic profile? Thanks a lot in advance =) |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field | lakeat | OpenFOAM Community Contributions | 58 | December 23, 2021 02:36 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[Netgen] How to refine mesh? | skovhus | OpenFOAM Meshing & Mesh Conversion | 0 | February 23, 2010 12:30 |