|
[Sponsors] |
November 18, 2020, 00:47 |
Viewing results with overset
|
#1 |
Member
Join Date: Feb 2014
Posts: 32
Rep Power: 12 |
Hi all,
I have tried to solve the twoSimpleRotor example of OpenFOAM2006. Things work well, but when I plot the results in ParaFoam I see on the the U around the object (in the overset) and the fields itself is 0. I did use the threshold filter to cut cells with cellType=0. Any ideas? I found out the problem: I didn't run the tutorial properly. All is well. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error Interpolating Results onto New Mesh | nammeh | CFX | 1 | March 26, 2019 12:08 |
Save Results automatically by APDL Command | ansyxyz | ANSYS | 1 | June 5, 2018 08:16 |
Is overset mesh required? | ahildershavn@yahoo.no | OpenFOAM Running, Solving & CFD | 2 | August 4, 2017 03:23 |
Transient Run - Output "Time" in partial results? | evcelica | CFX | 2 | May 16, 2012 21:36 |
Suitability of OpenDX for viewing CFX 4.3 results | Jonathan Wall | CFX | 3 | April 4, 2000 08:09 |