|
[Sponsors] |
November 7, 2017, 06:53 |
General Postprocessing
|
#1 |
Member
Fridrik Magnusson
Join Date: Aug 2017
Location: Denmark
Posts: 34
Rep Power: 8 |
Hallo everyone
I need to postprocess my data. I would like to manipulate the data, there is loads of functions out there but i lack understanding of how to apply them, that's why i would like to make my own. From wallHeatFunc i get all the heat fluxes (Q) at the boundary, i would like to compare this value to the temperature of the cell (T) and multiply,subtract this with some constants(C1,C2), to be equal to A located at the same place of the heatflux ? something like: How do i do this relative simple equation? This is something like the Nusselt-number process made by Johan Magnusson http://www.tfd.chalmers.se/~hani/kur...esentation.pdf but i simply don't understand how to do this - Fridrik Magnusson |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
using fieldAverage library to average postprocessing | eelcovv | OpenFOAM Programming & Development | 32 | May 17, 2022 09:55 |
questions about General Momentum Source | cqlwj123 | CFX | 5 | February 11, 2020 05:44 |
General understanding of postprocessing in paraFoam | Gerrit | OpenFOAM Post-Processing | 2 | October 20, 2015 02:08 |
General ellipsoidal geometry in Gambit? | LJB | ANSYS Meshing & Geometry | 1 | September 28, 2009 02:13 |
Question about Postprocessing Using UDF(in tutoria | sarah_ron2002 | FLUENT | 1 | April 10, 2007 16:17 |