|
[Sponsors] |
April 13, 2018, 11:24 |
Simplified postprocessing and mapFields
|
#1 |
Senior Member
Nejc
Join Date: Feb 2017
Location: Slovenia
Posts: 196
Rep Power: 9 |
Hello.
I have a case that requires over 5 million cells to capture the geometry and boundary layer but that number makes postprocessing very cumbersome. Will I lose a lot of information (p, U, k, omega, stream tracing) if I make a new case with the same geometry and coarser mesh and then do mapFields for quicker rendering? Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cut piece of simpleFoam solution for postProcessing | sisetrun | OpenFOAM Running, Solving & CFD | 0 | October 10, 2017 05:06 |
Problems with decomposePar and mapFields | Fischlurch | OpenFOAM Running, Solving & CFD | 2 | October 7, 2016 07:51 |