|
[Sponsors] |
July 14, 2020, 02:58 |
Question about 'postProcess -func'
|
#1 |
Member
Haoran Zhou
Join Date: Nov 2019
Posts: 49
Rep Power: 6 |
Hi all,
I try to use sampleDict to extract the velocity of several points on my computer but after I execute 'postProcess -func sampleDictU' there is no 'postProcessing' folder. However, on my cluster this command works well. Is there anything that needed to be done before using the command 'postProcess -func sampledict*'? By the way, is it the problem caused by different versions? The OpenFOAM I installed on my computer is OpenFOAM-7 and the one on my cluster is OpenFOAM4.0. Best regards, Stan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about symmetry in Autodesk Cfd 2016 | ecto | Autodesk Simulation CFD | 0 | October 20, 2015 04:16 |
small question about the functionalities of topological changes in OpenFoam | ngj | OpenFOAM Running, Solving & CFD | 2 | February 28, 2013 10:02 |
Question Re Engineering Data Source | imnull | ANSYS | 0 | March 5, 2012 13:51 |
internal field question - PitzDaily Case | atareen64 | OpenFOAM Running, Solving & CFD | 2 | January 26, 2011 15:26 |
Poisson Solver question | Suresh | Main CFD Forum | 3 | August 12, 2005 04:37 |