|
[Sponsors] |
how to extract clipped cutting plane from flow solution |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 12, 2022, 11:01 |
how to extract clipped cutting plane from flow solution
|
#1 |
Member
Giles Richardson
Join Date: Jun 2012
Location: Cambs UK
Posts: 98
Rep Power: 13 |
Im using the sampling plane feature to extract a cut plane from flow solution with postProcess -func sampling-plane, and this generates a vtk file of the cutplane which works fine.
But, I want to be able to clip or bound the cutting plane to make it smaller. Is there any way to do this within the postProcess utility, or with toposet? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Will the results of steady state solver and transient solver be same? | carye | OpenFOAM Running, Solving & CFD | 9 | December 28, 2019 05:21 |
[swak4Foam] error when use swak4foam to calculate the mass flow rate of a cutting plane | ozs | OpenFOAM Community Contributions | 0 | September 4, 2017 22:52 |
Very strange/incorrect flow solution all of a sudden. | bndrylyr | FLUENT | 0 | March 21, 2017 15:44 |
initialize flow field with steady state solution | holg | FLUENT | 0 | July 13, 2009 17:10 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |