|
[Sponsors] |
February 15, 2023, 05:04 |
sampling Data vs. plot over line in ParaView
|
#1 |
Member
Join Date: Oct 2011
Posts: 49
Rep Power: 14 |
Hi,
i am new to this kind of postprocessing. Having the same geometry of a flat nozzle depending on it's mesh i get different results for the fluid velocity at the nozzles exit with the plot over line tool in ParaView. So, with OpenFOAM's sampling postprocessing tool i might also calculate the fluid velocity at the nozzles exit (along a line) plus i have interpolation schemes. What way is the correct one? ParaView plot over line or sampling with OpenFOAM? Mesh is tet dominant. Thanks, fanta |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] Paraview Line plot point data vs cell data. | nikorapk | ParaView | 0 | October 14, 2022 03:11 |
parallel run error cma-permission-denied | supvato | OpenFOAM Running, Solving & CFD | 3 | October 10, 2022 04:48 |
1.7.x Environment Variables on Linux 10.04 | rasma | OpenFOAM Installation | 9 | July 30, 2010 04:43 |
Problem of compilation OF 14Allwmake command not found | erik_d | OpenFOAM Bugs | 13 | September 13, 2008 21:45 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |