|
[Sponsors] |
April 1, 2010, 08:42 |
Boundary Layer separation
|
#1 |
Senior Member
Join Date: Nov 2009
Posts: 111
Rep Power: 16 |
Hello,
I'm working on a case @Re=40 000, I resolve the boundary layer and I would like to see its separation. How can I do that in ParaFoam? Apparently, best way to see that is to look at the streamlines and see where they detached from the wall. But in parafoam, even if I put a huge number of points in the streamline tool : Either it crashes or either it's not precise enough Does anyone suceed in visualising separation point? Thanks for the help |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Combining BCs: wall - outlet. Boundary layer disappears | MartinaF | OpenFOAM Running, Solving & CFD | 1 | July 20, 2009 18:14 |
CREATION OF BOUNDARY LAYER | Jibran Haider | FLUENT | 3 | August 1, 2008 00:33 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |