|
[Sponsors] |
May 19, 2015, 12:01 |
Baffle creation
|
#1 |
New Member
Michelangelo
Join Date: Apr 2015
Posts: 17
Rep Power: 11 |
Hi,
I have simulated motorbike but i have problem with the fairing. This part is defined as a baffle so I created the topoSetDict in which I picked up the faces from the patch and the relatives cells. Then I run createBaffleDict but it creates only master side and not slave side. I am asking if someone have any ideas to solve the problem. Thanks |
|
May 21, 2015, 05:27 |
|
#2 |
New Member
Michelangelo
Join Date: Apr 2015
Posts: 17
Rep Power: 11 |
I solved the problem.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problems using createBaffles to create a 3D thermal baffle | zfaraday | OpenFOAM Running, Solving & CFD | 10 | September 6, 2017 17:07 |
[snappyHexMesh] handling of baffle regions or surfaces with zero thickness with snappyHexMesh | StSchiff | OpenFOAM Meshing & Mesh Conversion | 5 | March 8, 2017 09:45 |
[ANSYS Meshing] Oscillatory baffle column mesh creation in Workbench | mayj | ANSYS Meshing & Geometry | 1 | July 24, 2013 08:40 |
Boundary baffle error 258 | Nalleli | Siemens | 2 | November 19, 2006 13:14 |
baffle in flow route | GaryWang | CFX | 0 | October 23, 2005 23:19 |