|
[Sponsors] |
March 29, 2016, 12:23 |
Changing Unv File to Foam format-Error
|
#1 |
New Member
Maral Mohajer
Join Date: Jan 2016
Location: Stuttgart
Posts: 18
Rep Power: 10 |
Hello Everyone,
I'm modelling a box which has a shaft in it and this shaft is attached to the box from the top but its not continued till bottom. I created geometry and then mesh and as I wanted to use ideasUnvToFoam .... it doesn't work and therefore there is no constant folder ! Does anyone among experienced people have any idea what can be wrong that I receive this error segmentation fault , core dumped I would be thankful for responces. Regardssss Maral |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
Compiling problems with hello worldC | fw407 | OpenFOAM Installation | 21 | January 6, 2008 17:38 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |