Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

Turbine Meshing and Running

Updated Threads

Reply

Search this Thread

May 29, 2017, 05:02	Turbine Meshing and Running	#1
ashish.kumar New Member Ashish Kumar Join Date: May 2017 Location: MUMBAI Posts: 4 Rep Power: 8	Hello Everyone, I want to stimulate a turbine or in specific francis turbine. Can anyone help me in the meshing of the turbine or suggest some meshed geometry available online or any other help. Which solver should I use for this task?

Reply

Tags

francis turbine, francis turbines, solver, turbine, turbine mesh

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] 3D coil mesh: can't create the volume?	RomainBou	OpenFOAM Meshing & Mesh Conversion	3	July 18, 2016 05:09
[ICEM] Turbine meshing issue	Neys Schreiner	ANSYS Meshing & Geometry	1	February 16, 2016 11:36
Running parallel case after parallel meshing with snappyHexMesh?	Adam Persson	OpenFOAM Running, Solving & CFD	0	August 31, 2015 22:04
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 10:49
[ICEM] Error when running in Batch Mode from Ansys Meshing	gerardosrez	ANSYS Meshing & Geometry	2	November 10, 2014 11:30

All times are GMT -4. The time now is 13:51.