OpenFoam Toposet

bineet_aero · November 3, 2020, 09:16

Hello,

I have a conjugate heat transfer problem, few electronic components being cooled directly by a fluid (immersion method of cooling) and i am using OpenFoam for this.

I am using toposet to identify different solid components inside the background mesh. Since some of the components are very thin (like a solder layer 0.1mm thick), i have to use a blockmesh with very high number of elements in each of the three axis. If the background mesh is not fine enough, toposet is unable to extract these thin solid components. I have to play with the backgroud blockmesh so as the toposet identifies all the solid cellZones successfully. Of course i can use snappy, but i do not think so i can get the same quality hexa mesh as given by blockMesh.

Any idea how to make sure that toposet identifies a particular cellZone successfully without using hit and trial with background blockMesh?

thanks

olesen · November 7, 2020, 04:23

I am not sure I have understood correctly. Is your mesh from a blockMesh, or a different source? If it is a blockMesh, what happened to the cellZones from it?

November 3, 2020, 09:16	OpenFoam Toposet	#1
bineet_aero Member Bineet Mehra Join Date: Aug 2013 Posts: 61 Rep Power: 12	Hello, I have a conjugate heat transfer problem, few electronic components being cooled directly by a fluid (immersion method of cooling) and i am using OpenFoam for this. I am using toposet to identify different solid components inside the background mesh. Since some of the components are very thin (like a solder layer 0.1mm thick), i have to use a blockmesh with very high number of elements in each of the three axis. If the background mesh is not fine enough, toposet is unable to extract these thin solid components. I have to play with the backgroud blockmesh so as the toposet identifies all the solid cellZones successfully. Of course i can use snappy, but i do not think so i can get the same quality hexa mesh as given by blockMesh. Any idea how to make sure that toposet identifies a particular cellZone successfully without using hit and trial with background blockMesh? thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Frequently Asked Questions about Installing OpenFOAM	wyldckat	OpenFOAM Installation	3	November 14, 2023 11:58
OpenFOAM Training, London, Chicago, Munich, Sep-Oct 2015	cfd.direct	OpenFOAM Announcements from Other Sources	2	August 31, 2015 13:36
OpenFOAM Foundation Releases OpenFOAM v2.3.0	opencfd	OpenFOAM Announcements from OpenFOAM Foundation	3	December 23, 2014 03:43
Suggestion for a new sub-forum at OpenFOAM's Forum	wyldckat	Site Help, Feedback & Discussions	20	October 28, 2014 09:04
64bitrhel5 OF installation instructions	mirko	OpenFOAM Installation	2	August 12, 2008 18:07

November 7, 2020, 04:23		#2
olesen Senior Member Mark Olesen Join Date: Mar 2009 Location: https://olesenm.github.io/ Posts: 1,685 Rep Power: 40	I am not sure I have understood correctly. Is your mesh from a blockMesh, or a different source? If it is a blockMesh, what happened to the cellZones from it?