 |
 |
 |
|
|
|
[Sponsors] | ||||
December 5, 2020, 20:41
|
Merging Paths using BlockMesh
|
#1 |
|
New Member
Matheus
Join Date: Jan 2020
Posts: 9
Rep Power: 6  |
Hello there, I'm trying to make an orifice plate geometry using blockMesh, so I used the arc function to create 3 cylinders stacked but now I have a doubt, each cylinder was created using 5 blocks and all of them have a inlet and outlet, but I can't figure out how to merge them in a way that results in one inlet and outlet, I also don't know how to set the initial condition once two paths are merged and would be very thankful if any of you guys could help me out.
I attached the blockMeshDict file and an image of the whole geometry. |
|
|
|
|
 |
| Tags |
| blockmesh, meshing, opeanfoam, orifice plate |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] blockMesh: merging two unmatching faces | pbe_cfd | OpenFOAM Meshing & Mesh Conversion | 7 | December 10, 2019 05:38 |
| [blockMesh] blockMesh multiple merging on same hex | krzychu111 | OpenFOAM Meshing & Mesh Conversion | 1 | December 20, 2018 00:03 |
| [blockMesh] blockMesh merging | ancolli | OpenFOAM Meshing & Mesh Conversion | 4 | May 13, 2016 18:11 |
| [blockMesh] block merging with blockMesh | vaina74 | OpenFOAM Meshing & Mesh Conversion | 0 | October 21, 2014 03:16 |
| [blockMesh] BlockMesh face merging | duderino | OpenFOAM Meshing & Mesh Conversion | 12 | June 23, 2010 05:56 |
Linear Mode
