 |
 |
 |
|
|
|
[Sponsors] | ||||
July 29, 2021, 11:06
|
Inlet inside the domain
|
#1 |
|
New Member
Join Date: Jul 2021
Posts: 6
Rep Power: 6  |
Hello,
I would like to create an inlet inside a domain, to simulate a gas injection from a solid region. I tried with createBaffles but it results on a "wall" type on which I could not impose any velocity. How is it possible to do this ? Thanks in advance ! |
|
|
|
|
 |
| Tags |
| inlet bc, inside volume |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| inlet boundary conditions inside domain | yxl1453 | OpenFOAM Pre-Processing | 0 | May 10, 2021 23:44 |
| [ICEM] How to get inflation layers on wall inside INLET domain | harshavardhanps383 | ANSYS Meshing & Geometry | 0 | February 28, 2021 11:54 |
| Energy balance in compressor | jmenendez | CFX | 7 | February 23, 2021 09:46 |
| CFX - specified domain intialization | qntldoql | CFX | 4 | September 28, 2020 10:28 |
| Subdomains inside a Domain | oliveira1820 | CFX | 3 | April 11, 2019 06:11 |
Linear Mode
