|August 21, 2010, 04:05||
two phase k-e turbulent wall function
Join Date: May 2010
Posts: 27Rep Power: 8
Sorry for the cross thread, I don't know which thread this question best belongs too.
I would like to know how to properly set up the k-e wall function and solver for wavy stratified flow. I have a thin liquid film which is flowing along a channel at low velocity (4m/s) therefore low Re. A gas is flowing over the thin film at a relatively high velocity (40m/s), therefore high Re. How do I set the turbulent model correctly so that I can capture the turbulence at the interface correctly? I am currently using interFoam as the solver.
Thanks in advance
|Thread||Thread Starter||Forum||Replies||Last Post|
|Compile problem||ivanyao||OpenFOAM Running, Solving & CFD||1||October 12, 2012 09:31|
|A girl fail to plot velocity profile when mesh changes + Wall function||asherah||STAR-CCM+||0||February 19, 2010 18:45|
|Wall function for DPM needed||AMusteykis||FLUENT||0||January 13, 2010 16:02|
|Compilation errors in ThirdPartymallochoard||feng_w||OpenFOAM Installation||1||January 25, 2009 07:59|
|Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug||unoder||OpenFOAM Installation||11||January 30, 2008 21:30|