|February 13, 2014, 11:44||
max iterations exceded in CHT
Join Date: Sep 2013
Posts: 29Rep Power: 5
i tried CHT with 2 fluids above a solid but unfortunately i am getting Maximum Iteration exceed on the fluid solving part, i tried changing the relaxation factor and even MaxIter_ , it was not beneficial. And the temperature involved is around 270 to 370 K and other BCs are seem to be fine.any suggestions??
And second doubt i have is, how can i confirm if solid and fluid patches are coupled.Because i made three cellzones using salome. and used splitMeshRegions -cellZone in Foam to form separate polymesh file. After splitting the interface automatically was categorized as type mapped wall.Is my procedure right??. This question arise because my solid temperature haven't changed a bit.
P.S: i saw many threads on "Maximum Iteration exceed" but i was not able to solve, which made me to post this
|Thread||Thread Starter||Forum||Replies||Last Post|
|y+ and u+ values with low-Re RANS turbulence models: utility + testcase||florian_krause||OpenFOAM||110||April 21, 2016 11:54|
|Moving mesh||Niklas Wikstrom (Wikstrom)||OpenFOAM Running, Solving & CFD||122||June 15, 2014 06:20|
|Micro Scale Pore, icoFoam||gooya_kabir||OpenFOAM Running, Solving & CFD||2||November 2, 2013 14:58|
|calculation stops after few time steps||sivakumar||OpenFOAM Running, Solving & CFD||7||March 17, 2013 07:37|
|Could anybody help me see this error and give help||liugx212||OpenFOAM Running, Solving & CFD||3||January 4, 2006 19:07|